Dome flat labels to bring them to life! Unisect 2160
Home Hand Doming Kits Dry Domes Doming Resins Doming Machines We Dome Your Labels About Dome It

Up

  

LONDON W15 3LL

Tel: +44 (0)700 078 5516
Fax: +44 (0)700 078 5517

E-mail: sales@unisect-resources.com

 

TECHNICAL DATA SHEET

2160

 

Unisect 2160 is a water white transparent polyurethane resin specifically created for use in the production of labels, and badges.

The resin system, when fully cured, exhibits excellent color stability and mar resistance and adhesion to all the types of substrates normally used in the production of badges and labels.

 

RESIN SPECIFICATION:

Part A :

PROPERTY

VALUE

Color

Water White

Specific Gravity at250C

1.04 ± 0.01

Viscosity at 250C

290 ± 30 mPa.s

Part B:

 

PROPERTY

VALUE

Color

Water White

Specific Gravity at250C

1.08 ± 0.01

Viscosity at 250C

100 ± 10 mPa.s

NCO Value

32.0 ± 0.2 %

 

TYPICAL CURED ELASTOMER PROPERTIES:

 

PROPERTY

VALUE

Colour

Water White

Specific Gravity at 250C

1.06 ± 0.01

Mix Ratio By Volume

2:1 Part A : Part B

Shore 0D Hardness

52 ± 5

Tensile Strength

80 MPa

Elongation at Break

200 %

Gel time 100 gm Mass at 250C

6-8 mins.

UV Stability – QUV**

No yellowing after 4000 hrs

** QUV Weatherometer Test – 8hrs UV exposure at 60°C using lamp with peak emission at 340 nm, followed by 4hrs at 50°C and 95% humidity in a continuous cycle.

All of the above tests were carried out on specimens cured at 250C for 7 days.

Although the elastomer is not fully cured for 7 days in practice the material can be handled without damage after 12-24 hours at 250C

PACKAGING:

Unisect 2160 resin system is available in 25 liter and 200 liter drums.

 

RESIN STORAGE AND HANDLING:

The resin system should be stored under clean dry conditions and out of direct sunlight at a temperature between 150C and 250C. At low temperatures the Part B of Unisect 2160 resin system may crystallize and should this happen customers are advised to contact Unisect Resources Ltd for advice.

All skin and eye contact with Unisect 2160 resin system should be avoided and the resin system should be used in an area where adequate ventilation is provided and where there is no possible contact with foodstuffs.

Before using Unisect 2160 resin system users should familiarize themselves with the Health and Safety Data Sheet for the product.

 

To the best of Unisect Resources Ltd’s knowledge the information given in this Data Sheet is correct. However since use of the product is beyond the control of Unisect Resources Ltd users must determine for themselves the suitability of the product for their use and no responsibility is or will be accepted for problems or damage arising from the resin’s use. No guarantee is given or implied except other than the quality of the resin nor is freedom from patent restrictions to be inferred from these data.

 
           
Email: info@domeit.pottingsolutions.com
Copyright © 2003 - 2008 DomeIt
Last modified: March 29, 2008